If I didn't have bad luck I'd have no luck
- dopdog
- Posts: 934
- Joined: Tue May 04, 2010 6:50 am
- Name: Simon Boulter
- Location: Oxfordshire
Re: If I didn't have bad luck I'd have no luck
NO WAY!! is that from when it was installed?
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: If I didn't have bad luck I'd have no luck
Rob, Silvertop doesn't, Blacktop does...
And today I ran over something on the M25 which has buckled the 19" alloy on the Jag. I had to change the wheel on the side of the motorway for one of those stupid space savers and then gone on to Birmingham. New wheel and tyre will be required
And today I ran over something on the M25 which has buckled the 19" alloy on the Jag. I had to change the wheel on the side of the motorway for one of those stupid space savers and then gone on to Birmingham. New wheel and tyre will be required

- dopdog
- Posts: 934
- Joined: Tue May 04, 2010 6:50 am
- Name: Simon Boulter
- Location: Oxfordshire
Re: If I didn't have bad luck I'd have no luck
I would give up and go with public transport.
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: If I didn't have bad luck I'd have no luck
Idler had seized/failed and then bent the bolt holding it on 
Damage is 4 exhaust valves and 2 inlet, guides are fine and the pistons have some very minor marks..

Damage is 4 exhaust valves and 2 inlet, guides are fine and the pistons have some very minor marks..
- adithorp
- Posts: 1200
- Joined: Thu Jul 02, 2009 8:26 am
- Name: adrian thorp
- Location: Hyde, Manchester
Re: If I didn't have bad luck I'd have no luck
I'm amazed that bent the bolt.
I've had zetec engined cars arrive (still running) with screeming noises. Found the idler or adjuster siezed with the plastic pulley worn/melted flat on one side and a load of play in the belt... but still managed to drive in running!
I've had zetec engined cars arrive (still running) with screeming noises. Found the idler or adjuster siezed with the plastic pulley worn/melted flat on one side and a load of play in the belt... but still managed to drive in running!
- dopdog
- Posts: 934
- Joined: Tue May 04, 2010 6:50 am
- Name: Simon Boulter
- Location: Oxfordshire
Re: If I didn't have bad luck I'd have no luck
so the bad luck has turned good then! not as bad as it could have been.
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: If I didn't have bad luck I'd have no luck
I think the tensioner has gone as well which resulted in the idler issue rather than the other way round.
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: If I didn't have bad luck I'd have no luck
Car is running, should get it back Thursday. Now has a metal tensioner and idler pulleys.
- dopdog
- Posts: 934
- Joined: Tue May 04, 2010 6:50 am
- Name: Simon Boulter
- Location: Oxfordshire
Re: If I didn't have bad luck I'd have no luck
Will that be ready for north weald then?
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: If I didn't have bad luck I'd have no luck
Yeap....entry is in.
Return to “Jeremy Philips Cars”
Who is online
Users browsing this forum: No registered users and 21 guests