Tomorrow - promise
Rich
Richard's J15 build diary Update June 18th new pics
- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 8th Jan 2010!
When you're in it up to your neck - keep your mouth shut!
- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
And good to my promise here we go!!
OK these show the ally bobbin I had machined for the handbrake cable to pivot on, the run of the cable through the car and the run of the cable from the rear brakes. Powdercotaed floor looks really scratched in the flash - not really that bad though and going under the seats and a rubber mat






Here's the loom attached to the engine with the run across the top of the injectors.

Tray made up to look after the ECU in the passenger side pod


Final pictures are of the panelling we've been doing over the last couple of evenings.




Getting there slowly!!
More panelling this week then it's all off to the powdercoaters again!
Once we've finished in the engine bay we'll fit the rear body clam and I'll get it measured for an exhaust.
So what do you think?
Cheers for now
Rich
OK these show the ally bobbin I had machined for the handbrake cable to pivot on, the run of the cable through the car and the run of the cable from the rear brakes. Powdercotaed floor looks really scratched in the flash - not really that bad though and going under the seats and a rubber mat






Here's the loom attached to the engine with the run across the top of the injectors.

Tray made up to look after the ECU in the passenger side pod


Final pictures are of the panelling we've been doing over the last couple of evenings.




Getting there slowly!!
More panelling this week then it's all off to the powdercoaters again!
Once we've finished in the engine bay we'll fit the rear body clam and I'll get it measured for an exhaust.
So what do you think?
Cheers for now
Rich
When you're in it up to your neck - keep your mouth shut!
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
Looking good, some nice progress 

- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
jeffw wrote:Looking good, some nice progress
Thanks - bit slow at the moment but hopefully get the chance to do a lot more now.
Cheers
Rich
When you're in it up to your neck - keep your mouth shut!
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
Well it is still damn cold in my garage so all the jobs I was doing have stopped for the moment.
- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
Even with the portable heater running it's still chilly out there - workshop is deatched from the house and I've got an portable rad running out there during the cold months!!
Cheers
Rich
Cheers
Rich
When you're in it up to your neck - keep your mouth shut!
- RobMsport
- Posts: 704
- Joined: Thu Jul 02, 2009 2:36 pm
- Name: Rob Farley
- Location: Aston Clinton , BUCKS
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
My shed is 20 ft x 20 ft and it's very cosy to work in after the fan heater's been on for 20 minutes . I point it down to floor level then go back indoors for a coffee before doing anything in there and it's just a very small heater 3x10x12 inches .
Do I recall you saying you're in the Watford area
I'd love to take a peek sometime 
Do I recall you saying you're in the Watford area


- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
I'm in Ruislip, about 8 miles from Watford - pop over anytime just let me know when you'd like to visit. Tea/coffee biscuits all part of the service!!
Cheers
Rich

Cheers
Rich
When you're in it up to your neck - keep your mouth shut!
-
- Posts: 62
- Joined: Thu Jul 02, 2009 12:16 pm
- Name: Chet Galek
- Location: USA
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
Rich -
Any additional progress you can share?
Thanks
Chet
Any additional progress you can share?
Thanks
Chet
- Spectre 3
- Posts: 96
- Joined: Wed Jul 01, 2009 1:54 pm
- Name: Richard Claydon
- Location: Ruislip, Middx
Re: Richard's J15 build diary Update 20th Jan 2010 - Pictures!
Photo taking tomorrow!!
Been really busy with work recently - I know I keep saying that - but have finally finished the promotion round and have been successfull!!
More tomorrow I promise.
Rich
Been really busy with work recently - I know I keep saying that - but have finally finished the promotion round and have been successfull!!
More tomorrow I promise.
Rich
When you're in it up to your neck - keep your mouth shut!
Return to “Jeremy Philips Cars”
Who is online
Users browsing this forum: No registered users and 11 guests