Page 1 of 1
Fury rollbar/ally tank wanted
Posted: Fri Jul 08, 2011 3:57 pm
by CRAIGR
May be in need of a fury rollbar with the 4 harness fixings in it soon if anyones gone to a cage or has one kicking around gathering dust.
Also after an ally fury tank too.
Re: Fury rollbar wanted
Posted: Thu Jul 14, 2011 12:28 pm
by Jek
Hi Craig,
I have a new and unused 'extra height' roll bar for a Fury powdercoated in black. It has mounts on a horizontal bar for four point harnesses.
There is a slight catch though, its wasn't a great fit in my car (BGH supplied, so no real suprise there!). The problem is that the brackets on forward facing braces which bolt into the sides of the cockpit are a few mm too close together, and don't quite lie flush on the 2x1" chassis rail (out by about 10deg I'd say).
I can take a few photos of the misalignment for you to have a look at if you like. It could be made to fit as is I reckon, or for a perfect fit you could just chop off the lower brackets and weld them on at the correct spacing and angle.
Willing to let it go for £50 if that sounds reasonable?
Jek
Re: Fury rollbar wanted
Posted: Fri Aug 12, 2011 1:45 pm
by CRAIGR
anyone ??
Re: Fury rollbar wanted
Posted: Sat Aug 13, 2011 7:03 pm
by Jek
Hi Craig,
Just noticed your PM sitting in my inbox - sorry for the late reply! I'll try and get some photos of the taller hoop besides the standard height one for comparison when I'm home next weekend.
Jek
Re: Fury rollbar wanted
Posted: Sat Aug 13, 2011 9:12 pm
by CRAIGR
Nice one Jek
Look forward to some pics .
Re: Fury rollbar/ally tank wanted
Posted: Wed Aug 31, 2011 5:15 pm
by Jek
Hi Craig,
Sorry for the slow reply, I was sent away with work on short notice. I've managed to get a couple of photos of my roll hoop, but unfortunately it only has harness fixings for three point harnesses, i.e one on each side. I could have sworn it had four.
Sorry about that, good luck with the hunt!
Jek