JPSC Forum

Hi all,

After a 2.0 duratec engine, ideally from a st150/later mondeo/focus with the better flowing head. Will also consider an engine already set up for rwd if there is one about.

What have you got??? Please send me a message

I don't have an engine, but I do have some of the bits to go rwd if you're interested:
1) loggyboy sump, made in stainless by me. It's solid. It will need the dipstick sorting (it has the take-off pipe already in place, but you need to adapt your dipstick. It also will come with one already cut and one brand-new pickup pipe.
2) nearly new water-rail by Dunnel. It's never been on a car but has a few mild scratches from trial fitting. It doesn't fit with my packaging, and I went for an SBD/Laminova/electric water pump arrangement instead

Good luck on your hunt.

I could be interested in the water rail. Been scratching my head over the options and at the moment as I haven't got room for the water pipe on the inlet side. Moving it to the other side is favorite but expensive!

No Problem - it's just sat there in my cabinet. I of course have all the parts and the Dunnel manual/tech spec that he gives with every part (he's a thorough chap).

ping me if you want it - I'll photograph the scratches (it's never been on a car) and I think I paid 80% of retail for it from someone no LCB.

Many thanks
M

furyrebuild wrote:No Problem - it's just sat there in my cabinet. I of course have all the parts and the Dunnel manual/tech spec that he gives with every part (he's a thorough chap).

ping me if you want it - I'll photograph the scratches (it's never been on a car) and I think I paid 80% of retail for it from someone no LCB.

Many thanks
M

PM sent