Page 1 of 1

15" build wheels with T1R tyres

Posted: Thu Jun 25, 2015 9:44 am
by NeilEverett
My alloys rather suffered in my recent run-in with another car, Mojo has been treated to a new set!

Personally I think they are beyond economic refurbishment, but would make a fine set of build wheels, with the added advantage that 2 of the tyres were only replaced last September so have most of their original tread remaining, so could be re-used further down the line.

Tyres are 195/50/15 Toyo T1R which I've found good for my 'everyday use' with occasional trackdays.

Wheels are Inovit Rapid 15x6.5 ET38 Multistud fit (4x100 and 4x108) which weigh ~6.5Kg without tyres. Includes 3 spigot rings for Ford hubs (4th one broke up on removal so has been binned).

Wheels themselves are a mixed bag; in order from worst to best (pics of damage below):

No1 has significant scoring to the spokes & machined edge + >80% worn T1R
Image
Image

No2 has surface marks to the spokes and some scoring to the machined edge, missing centre cap + >80% worn T1R
Image
Image

No3 has a short section of damage to the machined edge + <10% worn T1R
Image

No4 is undamaged + <10% worn T1R

£75 collected from Warwick (Tyres cost me ~£90 last Sept)