1) GSXR Throttle bodies stripped of secondary butterfly and ready to be re-spaced to suit new engine. The fuel rail is supplied with them as is the TPS, inlet clamps and outlet rubbers but no injectors (see below). I am unsure if these are GSXR1000 or 1300 but the inlet diameter is circa 49mm and outlet side is circa 42mm (my vernier is at work but if you want me to double check this I can do so tomorrow?). I would like £75 collected or £85 delivered by UPS.
2) Duratec inlet manifold plate. This is originally from DanST Engineering and is new and unused. £15 including delivery (or £10 collected)
3) 4 off Honda Blackbird Injectors to suit above. These have been fully serviced and tested and all work 100% as new. They are good for about 335cc/min @ 43psi so 250bhp+ should be no problem. I can't put a picture of them up right now as they are in my draw at work! (I will pop a picture up tomorrow when I get a chance). It cost me £50 just to get them cleaned and tested so I think £75 collected or £85 delivered by UPS is a good price?
Any questions then PM me
