Page 1 of 1
sylva pheonix front and rear width of car
Posted: Thu Feb 14, 2013 9:00 pm
by striker1660
can anyone help, looking to use a pheonix type body on an alternative chassis. can anyone confirm the width of car front and rear outer edge of tyre. Also tyre size and wheelsize/offset. thanks.
Re: sylva pheonix front and rear width of car
Posted: Fri Feb 15, 2013 12:01 pm
by philfingers
If it's any help my old Phoenix was actually a striker underneath, so windscreen 'A' cut off and brackets added for the bonnet front hinge frame
viewtopic.php?f=4&t=590
Re: sylva pheonix front and rear width of car
Posted: Fri Feb 15, 2013 11:10 pm
by striker1660
hi phil, thanks for the reply. I am looking for the outer width, did your link hae this as i looke dthrough ans didn't see any text referening this as such.paolo
Re: sylva pheonix front and rear width of car
Posted: Tue Feb 19, 2013 8:22 pm
by matt_gsxr
Front outside of tyre to outside 145cm.
Rear outside to outside 153cm.
This is an STM body, IRS chassis, square tube.
Wheels are 14inch Compomotives 6inch wide, these are standard ford offset.
Any wider at the rear would be a problem. The front could probably handle an extra cm, although not sure about the lock for that.