Hi folks
I'll keep this short and sweet.
I am getting my Mojo back on the road after a while in storage.
Whilst my primary aim is to get the car up and running [on twin 40's] I would like to move to mapped ignition with MAP as the load sensor.
I have done some research but the cvh isn't that well supported on the whole compared to other engines. IMO.
Now has anyone used or installed a aldon amethyst unit for the cvh engine?
Now I am no stranger to exciter type sensors[in fact I designed and built the speedo input using the offside front brake disk and a hall effect switch on the mojo] but the amethyst would be the simplest way for me to get mapped ignition at this stage of the game.
So any takers? does anyone still run with the CVH and if do so, do you use aftermarket ignition control?
cheers
Andy Brown.
The CVH and aftermarket ignition
-
- Posts: 12
- Joined: Sun Nov 11, 2018 2:56 pm
- Name: Andrew
- Location: Carse of Gowrie
- peter030371
- Posts: 447
- Joined: Wed Jul 01, 2009 1:37 pm
- Name: Peter Smith
- Location: Hawkhurst
Re: The CVH and aftermarket ignition
Sorry can't help you with the Aldon unit but I have seen many good setups using the Nodiz controller
Editor of 'The Proper Job'
Return to “Jeremy Philips Cars”
Who is online
Users browsing this forum: No registered users and 121 guests