Winter update. I have now fitted half doors to both sides and a standard RAW vinyl boot cover.
Taxed the car over the weekend and waited for the roads to dry. Eventually, yesterday afternoon, I managed to get out in her for 10-15 minutes on my normal 'test' route and up to circa 80mph the reduction in buffeting is very noticeable in the cockpit. Very pleased with the results
Now need to do something about fitting a rear 'diffuser' to reduce rear drag (not in any attempt to pretend it will generate downforce!) and the car is getting better with each mod
Half doors
- peter030371
- Posts: 449
- Joined: Wed Jul 01, 2009 1:37 pm
- Name: Peter Smith
- Location: Hawkhurst
Re: Half doors
Editor of 'The Proper Job'
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: Half doors
Diffuser will help with the parachute effect that normal kit car bodies produce.
- peter030371
- Posts: 449
- Joined: Wed Jul 01, 2009 1:37 pm
- Name: Peter Smith
- Location: Hawkhurst
Re: Half doors
jeffw wrote:Diffuser will help with the parachute effect that normal kit car bodies produce.
I no, I had got a GPR diffuser to fit but by the time I trim the width down (10mm each side) it will take the outer strakes off and will look a bit daft with inner strakes and no outter strakes (the inners are moulded in so can't be removed). More to the point it will lose its strength without the outter strakes. Think I will have to sell this GPR one on and after lots of measurements and cardboard models I think I can make one from Carbon NV fit with some cutting about
Editor of 'The Proper Job'
-
- Posts: 2605
- Joined: Wed Jul 01, 2009 12:31 pm
- Name: Jeff Wiltshire
Re: Half doors
I'm pretty sure I bought a standard Westfield one which fitted. It was a Plays Kool one.
http://www.plays-kool.co.uk/acatalog/Fi ... ducts.html
http://www.plays-kool.co.uk/acatalog/Fi ... ducts.html
- peter030371
- Posts: 449
- Joined: Wed Jul 01, 2009 1:37 pm
- Name: Peter Smith
- Location: Hawkhurst
Re: Half doors
jeffw wrote:I'm pretty sure I bought a standard Westfield one which fitted. It was a Plays Kool one.
http://www.plays-kool.co.uk/acatalog/Fi ... ducts.html
The one I am looking at is a Westfield (narrow) one from Carbon NV. The width looks spot on but the length will need 'adjusting' with a jig saw to fit
Me being a weight watcher I can get a GRP one like you suggest for about £100 which weighs circa 3.5Kg or a Carbon NV one for just over £200 but weighs less than 1.5Kg. Guess which one I will be going for
I haven't got time to fit it just yet so that will be later in the year now.
Editor of 'The Proper Job'
- adithorp
- Posts: 1198
- Joined: Thu Jul 02, 2009 8:26 am
- Name: adrian thorp
- Location: Hyde, Manchester
Re: Half doors
Are you sure about those figures? The standard weight saving/cost diminishing return chart (and carbon is usually well down the chart) says that double the cost can't get you more than 50% weight saving.
- peter030371
- Posts: 449
- Joined: Wed Jul 01, 2009 1:37 pm
- Name: Peter Smith
- Location: Hawkhurst
Re: Half doors
adithorp wrote:Are you sure about those figures? The standard weight saving/cost diminishing return chart (and carbon is usually well down the chart) says that double the cost can't get you more than 50% weight saving.
The weights and prices are off the websites.
Editor of 'The Proper Job'
Return to “Jeremy Philips Cars”
Who is online
Users browsing this forum: No registered users and 4 guests