air in a composite
Posted: Sun May 15, 2016 10:34 pm
So, I've been putting various parts under the microscope. I've got some pictures here, but most of the detail is in my blog http://www.furyrebuild.co.uk.
Here are the bubbles, between 0.1 and 0.5mm in size.
Here is an infusion with no air ingress.
here is the part where I've used peel-ply to give the part a key when I bond it to the chassis.
Here are the bubbles, between 0.1 and 0.5mm in size.
Here is an infusion with no air ingress.
here is the part where I've used peel-ply to give the part a key when I bond it to the chassis.