I have noticed that my trailing arms on the rear are slightly banana shaped. This has caused the rake to drop a little.
Two questions for the forum.
Is there a preferred supplier of steel both the rectangular section, the suspension pick-up and the short length of cylindrical tube as well as the rubber bushes?
Should I rose joint one end so that I can get half turn adjustment on the rose joint. I remember years ago that this should only be done at one end.
Also is there any advantage to making them J shaped? I think this was done so that could run slightly longer dampers.
I tried using the search function but not coming up with a lot.
Dave
Trailing arms
- pigeondave
- Posts: 397
- Joined: Wed Oct 05, 2011 4:16 pm
- Name: David Malenczak
- Location: Brighton
Return to “Jeremy Philips Cars”
Who is online
Users browsing this forum: No registered users and 2 guests