Greetings one and all.
Posted: Wed Jul 08, 2009 7:31 pm
by Avagolen
Hi, This is Len from South Oxfordshire. Presently preparing for the collection of one Fury kit from BGH. Looking forward to keeping the spanners clean on nice new nuts and bolts.
Re: Greetings one and all.
Posted: Wed Jul 08, 2009 8:29 pm
by jeffw
Good luck with the build
What engine are you putting in ?
Re: Greetings one and all.
Posted: Sun Jul 12, 2009 9:56 pm
by Avagolen
Hi Jeff,
Well, being adventurous as I am, I am planning a potential 2 stage install. Firstly I will be fitting the Donor 1.8 CVH, as I would really like to keep the registration and then proberly go for something a little more lively. I need to fit a set of bike carbs as I do not want to cut the bonnet - which I already have in the garage plus a set of delortoes if I decide to go that path. I have got a rear mounting thermostat housing, just have to make a blanking plate to close off the original water path to the inlet manifold. Should keep me quiet for a fair time.
Before anyone asks - I do have all of the documentation and even the original chassis plates as I bought, ran and stripped the Sierra. 1992 plate.
Len.